Power Systems-Design

Position Title: Power Systems – Design & Engineering Grade: Manager Location: Pune Job Role:  Power systems expert responsible for end-to-end design & engineering of power supply and control systems for a Green Fuel production plant, including substation, hydrogen plant, ammonia plant & ammonia storage. Ensures accurate and timely delivery of design documents, SLDs, schemes, BOQs, evaluations, value engineering, and team management. Key Functional Roles & Responsibilities:  •Lead design & development of HV/MV/LV (220/66/33/11kV) Power Electrical systems from concept to production (In-house/outsourced). •Formulate System requirements for Transformers, Switch yards, Converters/rectifiers, control systems •Design & development of Power distribution network within boundaries of GF plant. •Application of relevant reference standards for all in-house & outsourced systems e.g., IEC/IEEE/UL/CE/Grid Codes •Create and review single Line Diagrams and or Orthographic Diagrams for systems & sub-systems  •Create & review requirements for Software, SCADA system  •Guide/mentor Simulation team to review the results obtained from various campaigns & design data •Device operational safety & safety risk assessment of Power systems  •Create design requirement document Develop concept design and BOQ for techno-economic analysis •Design and detailed Engineering of Electrical substation and transmission line, power distribution network including AC and DC. •Electrical system study -Load flow study, power consumption, insulation coordination, protection & Automation system, communication system, power quality measurement, wind & solar park generator grid inter connection etc. •Design calculations, Electrical component selection & sizing calculation for transmission line, substation and AC /DC distribution system •Intime Technical support service to Project, OMS, SCM and marketing •Understand & apply Statutory and regulatory requirements and design approval from utilities and customers. •Conduct & review Fatigue Analysis of Electrical Components. • Explore power electronics hardware and software to enable efficient power conversion from renewable sources to electrolyzes. • Optimizing power conversion in the distribution system between the renewable source and Electrolyzer. • Develop new electrical architectures to enable efficient and balanced coupling between renewable sources and electrolyzes. • Developing cost reduction pathways for power conversion based on deep technical understanding and competitive intelligence from major Original Equipment Manufacturers. • Application of National Grid Codes and compliance verification process with Transmission System Operator and Distribution System Operator. • Technology development for powering GW scale electrolysis. • Ability to perform front-end engineering studies covering the following aspects of electrical system design: HV Cable sizing calculations • Reactive power simulation • (Steady state) load flow simulations • Short circuit current simulation • Insulation coordination • Control and protection study • EM-field and Influence study Supporting Roles & Responsibilities •Team building and competency improvement •Work with cross-functional/cross-discipline teams during whole process •Communicating closely with Vendors during the entire development process, prototype validation and functional tests of components. •Fault analysis and required RCA for corrective and preventive action. •Risk assessment, analysis and management throughout the development process •Design value Engineering and continuous improvement through market research, innovation and brain storming. •Create and continuous improvement of various systems Educational Qualification Bachelor’s or Master’s in Electrical Engineering from a reputed institute Experience in power plant, transmission & distribution system design Relevant Experience: 10+ years in relevant areas Skills and Competencies: a) Advance level of skills in design of substation including design calculation. b) Good Knowledge on handling of   design software like etap, Mypower, Excel templates, AutoCAD c) Proven track record in industry-relevant electrical engineering software packages such as Digsilent/Powerfactory, ETAP, and PSCAD. d) Good knowledge on Power system protection, automation and communication system e) Knowledge on design of  Electrical transmission lines  f) Additonal  knowledge on Solar, wind & hybrid  park shall be given advantages g) Good  skills in drafting documents, design concept presentations, team and management communications. h) Knowledge on Various Indian and international design and construction practices and standards.